Culligan Mark 100 Instrucciones de operaciones descargar pdf (Pagina 10)

8 CULLIGAN

MARK 100 WATER SOFTENER

FIGURE 4 FIGURE 5

FIGURE 6

CAUTION: When reinstalling back plate to control valve, make sure the u-clip

fully engages the two bottom holes of the bracket (Figure 6). Secure bracket from

the top with the two mounting screws provided.

FIGURE 7

CONNECT THE BRINE LINE

Refer to Figures 6 & 7.

• Use the length of brine line included in the

brine tank, or measure a length of brine line

sufficient to reach from the brine tank to the

brine fitting, with no sharp bends. For easier

access to the float it is recommended to add an

extra four feet (1.3 meters) of length to the brine

line. Cut both ends of the brine line squarely

and cleanly.

• Remove the brine valve from the brine tank

and then remove the white nut and insert from

the float rod. Return float rod to its original po-

sition.

• Slip the white nut over one end of the tubing

and press the plastic insert into the end of the

tubing (Figure 7). Connect to the brine valve

and tighten nut.

• Remove white nut from the brine connection,

and remove the plastic insert from the brine

connection fitting.

• Slip the white nut over one end of the tubing

and press the plastic insert into the end of the

tubing (Figure 7). Connect to the brine connec-

tion on the valve and tighten nut (Figure 6).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

Sin comentarios

Culligan Mark 100 Instrucciones de operaciones Pagina 10