Culligan Mark 100 Instrucciones de operaciones descargar pdf (Pagina 17)

Press ▲ to increase or

▼ to decrease

Press ▲ to increase or

▼ to decrease

Press ▲ to increase or

▼ to decrease

SETTING THE MICROPROCESSOR

The microprocessor senses when it is installed as a Soft-Minder or Aqua-Sensor

control. Adding or removing

any connection to the board while power is on, or flipping any of the dip switches will automatically reset the

microprocessor to the factory settings.

1. With a flashing or blank display,

pressing the status button twice will

move to the Time-of-Day adjustment.

Adjust the time by using the up and

down arrows. A number “1” will appear

at the bottom of the display while in this

mode.

2. Press status again, this displays the

Time-of-Regeneration for delayed

units, adjust using the up and down

arrows. A number “2” will appear at the

bottom of the display while in this

mode.

3. Press status again, the number “3” will

appear at the bottom of the display.

This setting is not used, and any

changes made will not affect the

operation of the microprocessor.

4. Pressing status again will show the Salt

Dosage. This can be adjusted with the

up and down arrows, the range is 3-15

lbs. for the 9” controls and 5-24 lbs. on

12” controls. A number “4” will appear

at the bottom of the display while in this

mode.

Press ▲ to increase or

▼ to decrease

The timer uses four buttons:

1. STATUS: Advance timer through display options.

2. UP ARROW: Increase the setting.

3. DOWN ARROW: Decrease the setting.

4. REGEN.: Initiate a manual regeneration.

FIGURE 13 - Circuit Board Display

Make sure the inlet water supply is turned off, then supply power to the timer. The display will power up flashing

"12:00 PM". After 1 minute the motor will energize and cycle the control, without stopping, to the home

position. This is required to ensure that the control is in the home position.

Programming

PROGRAMMING 15

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Comentarios a estos manuales

Sin comentarios

Culligan Mark 100 Instrucciones de operaciones Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Culligan Mark 100