Culligan Mark 100 Instrucciones de operaciones descargar pdf (Pagina 8)

6 CULLIGAN

MARK 100 WATER SOFTENER

PLACEMENT

Refer to Figure 1 for system placement.

• Set the media tank on a solid, level surface near water, drain and electrical facilities. Place the outlet (black

coupling) of the tank on the left.

• Set the brine system on a flat, smooth, solid surface as near the media tank as possible.

MOUNT THE CONTROL VALVE

See Figure 2 for a visual on mounting the control valve to the tank.

• Remove and discard the protective covers on the tank couplings.

• Lubricate the o-rings on the tank couplings with silicone lubricant.

• Place the control on the tank couplings and press down firmly.

NOTICE: The white tank coupling is the inlet, and should be located on the inlet side (right side) of the control.

• Install the u-clamps on both sides of the control and secure with the screws.

TWELVE INCH SOFTENERS

As shipped from the factory, each control is equipped as a 9-inch unit. A 12-inch eductor nozzle and backwash

flow control are included with each unit for conversion for use with the 12-inch tanks.

NOTICE: To prevent injury, convert unit to a twelve-inch configuration prior to installation.

Refer to Figure 3 for a visual on changing the eductor nozzle and the backwash flow control.

Eductor Nozzle Replacement:

• Remove the three screws on the eductor cap and remove the cap.

• Remove the eductor assembly.

• Remove the eductor screen from the assembly

• Remove the blue nozzle and replace it with the beige nozzle. Make sure to put the o-ring on the beige

nozzle.

• Reverse the procedure to reassemble. To prevent leaks, ensure that the gasket is in the proper position.

Backwash Flow Control Replacement:

• Remove the drain clip and pull the drain elbow straight off.

• Remove the backwash flow control located behind the elbow. Put the #3 restrictor in its place.

NOTICE: The number on the flow control should face into the valve body.

• Reverse the procedure to reassemble.

FIGURE 1

Brine Tank

Softener

Drain Line

Hard Water In

Heater

Treated Water Out

Hose

Bibs

Water

Meter

Pump

Installation

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Comentarios a estos manuales

Sin comentarios

Culligan Mark 100 Instrucciones de operaciones Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Culligan Mark 100